1. How to use the rechargeable drill

1. Loading and unloading of rechargeable battery

How to remove the battery of the rechargeable drill: Hold the handle tightly, and then push the battery latch to remove the battery. Installation of the rechargeable battery: After confirming the positive and negative poles

Insert the battery.

2. Charging

Insert the rechargeable battery into the charger correctly, it can be fully charged in about 1h at 20℃. Note that the rechargeable battery has a temperature control switch inside, and the battery will be cut off when it exceeds 45°C.

It cannot be charged without electricity, and can be charged after cooling.

3. Before work

(1) Drill bit loading and unloading. Install the drill bit: After inserting the bits, drill bits, etc. into the chuck of the non-switch drilling machine, hold the ring tightly and screw the sleeve back tightly (theclockwise direction). During operation, if the sleeve becomes loose, re-tighten the sleeve. When tightening the sleeve, the tightening force will become stronger and stronger.

(2) Removing the drill bit: Hold the ring tightly and unscrew the sleeve to the left (counterclockwise when viewed from the front).

(3) Check the steering. When the selector handle is placed in the R position, the drill bit rotates clockwise (viewed from the back of the rechargeable drill), and when the selector handle is placed in the L position, the drill

Rotate counterclockwise (viewed from the back of the charging drill), “R” and “L” symbols are marked on the machine body.

Note: When changing the rotation speed with the rotary knob, please confirm whether the power switch is turned off. If the rotation speed is changed while the motor is rotating, the gear will be damaged.

4. How to use

When using a cordless drill, the drill must not get stuck. If it is stuck, turn off the power immediately, otherwise the motor or rechargeable battery will burn.

5. Maintenance and precautions

When the drill bit is stained, please wipe it with a soft cloth or a damp cloth dipped in soapy water. Do not use chlorine solution, gasoline or thinner to prevent the plastic part from melting.

The rechargeable drill should be stored in a place where the temperature is lower than 40°C and out of reach of minors.

2. What are the precautions for charging the rechargeable drill

1. Please charge at 10~40℃. If the temperature is lower than 10℃, it may cause overcharging, which is extremely and dangerous.

2. The charger is equipped with a safety protection device. After the rechargeable battery is fully charged, it will automatically cut off the power supply, so you can use it with confidence.

3. Do not let impurities enter the connection hole of the charger.

4. Do not disassemble the rechargeable battery and charger.

5. Do not short-circuit the rechargeable battery. When the rechargeable battery is short-circuited, it will cause a large current to overheat and burn out the rechargeable battery.

6. Do not throw the rechargeable battery into water, the rechargeable battery will explode when heated.

7. When drilling on the wall, floor or ceiling, please check whether there are buried wires in these places.

8. Do not insert objects into the vents of the charger. Inserting metal objects or flammable and explosive objects into the vents of the charger may cause accidental contact or damage to the charger.

device.

9. Do not use a generator or DC power supply device to charge the rechargeable battery.

10. Do not use unspecified pools, do not connect dry woodworkers to designated common pools, rechargeable pools or car storage pools.

11. Please charge indoors. The charger and the battery will heat up slightly during charging, so it must be charged in a cool, well-ventilated place with low temperature.

12. Lightly charge the power tool before use.

13. Please use the specified charger. Do not use unspecified chargers to avoid danger.

14. Be sure to use the charger under the voltage conditions specified on the nameplate.